Thermo Scientific EASY-nLC 1200 Troubleshooting And Maintenance Manual page 119

Thermo Scientific
Figure 80. Removing the screws underneath the hard-drive drawer
5. Unplug the hard drive from the SATA cable
Figure 81. Hard drive unplugged from the SATA cable
The SATA cable is connected to the hard disk. The pins on the hard drive fit in the same
place on the cable connector.
Tip If the SATA cable plug is difficult to access, remove the brass rod that holds the
cable down (Figure
back in the drawer afterward.
(Figure
SATA cable
82). Use a Torx T-8 wrench to remove the screws. Place the rod
5
Routine Maintenance
Replacing the Hard Drive
81).
Troubleshooting & Maintenance Guide 97