Thermo Scientific EASY-nLC 1200 Troubleshooting And Maintenance Manual page 118

5
Routine Maintenance
Replacing the Hard Drive
96 Troubleshooting & Maintenance Guide
❖ To remove the hard drive
1. Close down the EASY-nLC instrument, and turn off the power to the instrument (see
"Closing Down the EASY-nLC Instrument"
2. Loosen the two screws in the hard-drive drawer using a 2.5 mm hex wrench
Figure 78. Screws that secure the hard-drive drawer
3. Pull out the hard-drive drawer, as shown in
Figure 79. Pulling out the hard-drive drawer
4. Using a Torx T-10 wrench, remove the four screws underneath the hard-drive drawer that
secure the hard drive to the drawer
on page 22).
Two screws that secure the hard-drive drawer
Figure 79.
(Figure 80).
(Figure 78).
Thermo Scientific