Replacing The Monitor - Thermo Scientific EASY-nLC 1200 Troubleshooting And Maintenance Manual

Replacing the Monitor

Thermo Scientific
3. Reconnect all of the internal cables to the computer box.
• Figure 83 on page 102
EASY-nLC 1200 instrument.
4. Using a Torx T-10 wrench and the four screws that you removed in
secure the computer box to the instrument (see
5. Using a Torx T-10 wrench and the screws that you removed in
the back panel to the instrument.
Tip Do not reconnect the left side panel to the instrument housing until after you
recalibrate the autosampler.
6. Using a Torx T-10 wrench and the screws that you removed in
the top panel to the instrument.
7. Reconnect the cables to the back panel as follows:
• Reconnect the power cable to the back panel and to a laboratory power outlet.
• If the instrument was connected to a laboratory LAN port, reconnect the Ethernet
cable.
• If the instrument is part of a Thermo Scientific LC/MS system, reconnect the
Ethernet cable to the back panel of the instrument, and make sure that the other end
of the cable connects to the Ethernet switch for the data system hardware.
8. Turn on the EASY-nLC instrument and select admin in the User list.
9. Set the new administrator password and record the master key as described in the
EASY-nLC 1200 Getting Started Guide.
10. Recalibrate the autosampler (see
Replacing the monitor requires the following part and tools.
Tools
• Torx T-10 wrench
• 2 mm L-hex wrench or straight wrench
To replace the monitor, follow these procedures:
1. "To remove the monitor,"
2. "To install the new monitor"
shows the connections to the computer box inside the
Figure 85
Chapter 8).
Part
Monitor P/N LC282
next procedure
on page 107
EASY-nLC 1200 Troubleshooting & Maintenance Guide
6
Field Service Maintenance
Replacing the Monitor
step 7 on page
on page 104).
step 5 on page 102, secure
step 6 on page 103, secure
103,
105