Thermo Scientific EASY-nLC 1200 Troubleshooting And Maintenance Manual page 282

A
Error Codes
Table 30. Error codes (Sheet 4 of 8)
No. Issue code name
40 ERROR_SENSIRION_
IN_IDLE_MODE
41 ERROR_SENSIRION_
CALIBRATION
42 ERROR_RS232_INIT
54 ERROR_RS485_
COMMAND_VERIFY
55 ERROR_
MANIPULATOR_
UNKNOWN_RACK_
SHELF
56 ERROR_
MANIPULATOR_
UNKNOWN_RACK_
POS_ID
57 ERROR_
MANIPULATOR_SET_
GRID_CONFIG L
58 ERROR_
MANIPULATOR_SET_
WASH_CONFIG
260 EASY-nLC 1200 Troubleshooting & Maintenance Guide
Description
Cannot calibrate sensor in
idle mode.
Cannot store flows larger
than 9999 nL/min.
Initialization of interface
"PORT_NAME" failed
COMPONENT_ID
COMMAND failed:
ERROR_MESSAGE
Unknown rack shelf
RACK_SHELF_VALUE
Unknown rack position
id
RACK_POSITION_ID_
VALUE
Grid configuration
change failed
(AUTOSAMPLER_
RETURN_CODE)
Wash configuration
change failed
(AUTOSAMPLER_
RETURN_CODE)
Cause
Flow sensor in idle
mode during
calibration
Abnormal value trying
to be written to the
flow sensor
Access to interface
failed
Error occurred when
sending COMMAND.
Unknown rack shelf
position supplied to
driver
Could not move to bad
rack position.
Error uploading
autosampler plate
calibration
(0 = asrOK,
1 = asrBusy,
2 = asrBadLocation,
3 = asrBadCoordinate,
4 = asrEjected,
5 = asrAxisError,
6 = asrChecksumError)
Error while saving
autosampler wash
calibration (see code 57
for asr codes)
Solution
Turn off the EASY-nLC
instrument, and turn it
back on. Check the flow
sensor functionality.
Turn off the EASY-nLC
instrument, and turn it
back on. Check flow sensor
functionality.
Turn off the EASY-nLC
instrument, and turn it
back on.
Troubleshoot P-BUS
communication/hardware.
Verify that the sample
position is correct.
Verify that the sample
position is correct.
Calibrated position not
recognized by the
touch-screen application.
See Chapter 8, "Calibrating
the Autosampler's XYZ
Robot."
Calibrated position not
recognized by the
touch-screen application.
See Chapter 8, "Calibrating
the Autosampler's XYZ
Robot."
Thermo Scientific