Routine Maintenance
Thermo Scientific
To maintain the EASY-nLC instrument, follow the procedures in this chapter.
Tip You can access most of the instrument components by removing either the left or
right side panel of the instrument. Three captive quarter-turn screws secure each panel to
the instrument housing. To remove a side panel from the housing, loosen (unlock) the
screws from the housing by rotating them 90° counterclockwise. When loosened, the
screws rotate freely without constraint, but remain connected to the side panel.
For information about the suggested maintenance schedule and the built-in maintenance
scripts and record keeping features provided by the EASY-nLC touch-screen application, see
Chapter 3, "Maintenance Scripts and Service Records."
Contents
•
Maintaining a Clean Working Environment
•
Using Only UHPLC/MS-Grade Solvents
•
Refreshing solvents
•
Re-calibrating Flow Sensors
•
If a solvent refresh was acknowledged less than two weeks ago, this
button reads "Solvents Refreshed" (Figure 46).
•
Maintaining the Syringe Pumps
•
Replacing the Check Valves
•
Replacing Viper/nanoViper solvent lines
•
Replacing the Autosampler Needle
•
Replacing the Sample Loop
•
Replacing a Pressure Sensor
•
Replacing a Flow Sensor
•
Replacing the Hard Drive
•
Managing the Devices List
Troubleshooting & Maintenance Guide
5
65