Set Port Enable | Disable - Avaya G450 Cli Reference Manual

CLI Commands
Example
To specify that port 6/5 is an edge port:
G450-001(super)# set port edge admin state 6/5 edge-port
Related Commands
set port auto-negotiation-flowcontrol-advertisement,
set port flowcontrol,
admin status, set port
edge state, show port flowcontrol

set port enable | disable

Use the set port enable | disable command to enable or disable a port or a range of
ports.
Syntax
set port {enable | disable} module/port
Parameters
Parameter
enable
disable
module
port
User Level
read-write
Context
general
378 Avaya G450 CLI Reference
set port level, set port
speed, show port auto-negotiation-flowcontrol-advertisement,
Description
Enable a port
Disable a port
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 10/5-6 for
both ETH LAN ports 5-6 on the front panel.
set port duplex,
name, set port negotiation,
Ethernet port configuration
set port enable | disable,
set port point-to-point
show port
Possible Default
Values Value