OCTAVIA
Removing and installing parts of the exhaust system
Assembly overview of the exhaust system
1 - Shield
2 - Washer
3 - 25 Nm
4 - Lambda probe (G39), 50 Nm
♦ grease only thread with G052 112
A3; on no account allow G052 112
A3 to get onto the slot of the probe
body
♦ use lambda probe wrench for remov-
ing and installing (e.g. 3337)
♦ testing:
⇒ 1.8-ltr./92 kW Engine - Fuel Injection and
Ignition System; Repair Group 24
Edition 02.02
S00.5104.55.20
Exhaust System
5 - Clamping sleeve
♦ aligning exhaust system free of stress
⇒ page 26-5
♦ installation position: horizontal in
vehicle; bolted connection pointing to
the left
♦ tighten bolted connections evenly
6 - 40 Nm
♦ replace
♦ coat thread with hot bolt paste G 052
112 A3
7 - Hanger
8 - Front and rear silencer
♦ front and rear silencers are installed
as a single part in production. For
repairs, front and rear silencer are
supplied separately and for connect-
ing with a double clamp.
♦ aligning exhaust system free of stress
⇒ page 26-5
♦ replacing front and rear silencer
⇒ page 26-4
9 - Tunnel bridge
♦ with hole for aligning exhaust system
⇒ page 26-5
10 - Hanger
♦ pay attention to installation position
⇒ page 26-5
11 - Front exhaust pipe
♦ with catalytic converter
12 - Gasket
♦ replace
13 - Exhaust manifold
26
------------ 26-1 ------------