Exhaust system
Removing and installing parts of the exhaust system
Note
Always replace gaskets and self-locking
t
nuts.
Use a screwdriver to slacken and tighten
t
the clamps of the heat shield. Tightening
torque: 2 Nm
1 -
Tunnel bridge
with hole for aligning exhaust system
–
→ Chapter
2 -
Hanger
–
Fitting position
3 -
25 Nm
4 -
Front exhaust pipe
–
pay attention to different version
–
with oxidation catalytic converter
–
with separation point
–
protect against shocks and blows
Avoid a large deflection, max. deflection
–
10°
– removing and installing
5 -
40 Nm
–
replace
– coat with hot bolt paste -G 052 112 A3-
6 -
Gasket
–
replace
7 -
Exhaust manifold
– removing and installing
8 -
25 Nm
–
replace
→ Fig.
→ Chapter
→ Chapter
120