Rep 19.2.1 Rear Cover - Xerox WorkCentre 5021 Service Documentation

Figure 6 j0lj41909
6. Install the Right Cover as shown in the figure. (Figure 7)
Figure 7 j0lj41910
Repairs and Adjustments
REP 19.1.2, REP 19.2.1

REP 19.2.1 Rear Cover

Parts List on PL 19.2
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
1. [Machines with One Tray Module]: Remove the STM Connector Cover. (Figure 1)
(1) Remove the Thumbscrew (x2).
(2) Remove the STM Connector Cover.
2. [Machines with One Tray Module]: Disconnect the connector. (Figure 2)
(1) Release the Wire Harness from the clamp.
(2) Remove the cable band.
(3) Disconnect the connector.
08/2012
4-58
WARNING
Figure 1 j0yg41903
WorkCentre 5021/5019
Initial Issue