Show Ipv6 Ospf Neighbor - D-Link DGS-6600-48TS Manual

DGS-6604 m

show ipv6 ospf neighbor

show ipv6 ospf [PROCESS-ID] neighbor [IFNAME | NEIGHBOR-ID] [detail]
Syntax Description
PROCESS-ID
IFNAME
NEIGHBOR-ID
detail
Default
Command Mode
Usage Guideline
Example
Switch > enable
Switch # show ipv6 ospf neighbor
The result after executing this command is as follows.
OSPFv3 Process (null)
Neighbor ID
10.76.37.3
10.76.37.3
Total Entries: 2
CLI Reference Guide
To display IPv6 OSPF neighbor information on a per interface basis, use the
show ipv6 ospf neighbor command.
(Optional) Internally used identification parameter for an IPv6 OSPF routing
process. It is locally assigned and can be any positive integer. A unique value is
assigned for each IPv6 OSPF routing process.
(Optional) Interface type and number. If no option is specified, the command
applies to the entire IPv6 OSPF process.
(Optional) Neighbor ID. It can be specified as either a decimal value or as an
IPv4 address.
(Optional) Displays all neighbors in detail; lists all neighbors.
None
User EXEC
The keywords can be appended to all other keywords used with the show ipv6
ospf neighbor command to display the information desired.
The following is sample output from the show ipv6 ospf neighbor command
with the detail keyword.
The result after executing this command is as follows.
Pri State
1 Full/DR
1 Full/ -
Dead Time Interface
0DT0H0M33S
0DT0H0M38S
show ipv6 ospf neighbor
Instance ID
vlan2 0
VLINK1 0
714