3.
Push
or
4.
Push
or
5.
Push
or
The procedure to set the keypad language is complete.
◆
Set the Date and Time
The procedure in this section shows how to set the date and time.
Note:
• To set the drive to detect an alarm when the battery is dead or when the clock is not set, install the battery then set o4-24 = 1 [bAT Detection
selection = Enable (Alarm Detected)].
• If the keypad does not have a clock battery, you must set the date and time each time you energize the drive.
1.
Push
(Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push
(Menu).
YASKAWA TOEPYAIGA8002B GA800 Drive Programming
to select [Initial Settings], then push
to select [Language Selection], then push
to select the language, then push
, push
(Back) to show [Home] on
.
.
.
.
3.4 Keypad Operation
577
3