YASKAWA GA800 Programming Manual page 363

Note:
Refer to "Setting Procedures for Multi-step Speed Operation" in "d: Reference Settings" for more information.
■
4: Multi-Step Speed Reference 2
Setting Value Function
4 Multi-Step Speed Reference
2
Note:
Refer to "Setting Procedures for Multi-step Speed Operation" in "d: Reference Settings" for more information.
■
5: Multi-Step Speed Reference 3
Setting Value Function
5 Multi-Step Speed Reference
3
Note:
Refer to "Setting Procedures for Multi-step Speed Operation" in "d: Reference Settings" for more information.
■
6: Jog Reference Selection
Setting Value Function
6 Jog Reference Selection
■
7: Accel/Decel Time Selection 1
Setting Value Function
7 Accel/Decel Time Selection
1
Note:
Refer to "C1: Accel & Decel Time" for more information.
■
8: Baseblock Command (N.O.)
Setting Value Function
8 Baseblock Command (N.O.)
The keypad flashes bb [Baseblock]. If you cancel the baseblock command when the Run command is active, the drive
will restart the motor and use the speed search function.
ON : Baseblock (drive output stop)
OFF : Normal operation
YASKAWA TOEPYAIGA8002B GA800 Drive Programming
V/f CL-V/f OLV CLV AOLV
Uses speed references d1-01 to d1-16 to set a multi-step speed reference.
V/f CL-V/f OLV CLV AOLV
Uses speed references d1-01 to d1-16 to set a multi-step speed reference.
V/f CL-V/f OLV CLV AOLV
Sets the drive to use the JOG Frequency Reference (JOG command) set in d1-17. The JOG Frequency Reference (JOG command)
overrides Frequency References 1 to 16 (d1-01 to d1-16).
V/f CL-V/f OLV CLV AOLV
Sets the drive to use Acceleration/Deceleration Time 1 [C1-01, C1-02] or Acceleration/Deceleration Time 2 [C1-03, C1-04].
V/f CL-V/f OLV CLV AOLV
Sets the command that stops drive output and coasts the motor to stop when the input is ON.
Figure 2.79 Baseblock Command Time Chart
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
2.8 H: Terminal Functions
363
2