Write Automatically Backed-Up Parameters To The Drive - YASKAWA GA800 Programming Manual

2.
Push (Menu).
3.
Push or
4.
Push or
The keypad will show the drive information.
A - Drive Series
B - Maximum Applicable Motor Output
(HD/ND)
C - Rated Output Current (HD/ND)
◆

Write Automatically Backed-up Parameters to the Drive

You can automatically back up parameters to the keypad connected to the drive and write those parameters to a
different drive as specified by the settings of o3-06 [Auto Parameter Backup Selection] and o3-07 [Auto Parameter
Backup Interval].
Note:
• Set o3-06 = 1 [Auto Parameter Backup Selection = Enabled] in each drive to which you will write the parameters.
• This operation is not available when the parameters in the keypad and the parameters on the other drives are set to the same values.
1.
Connect the keypad to the drive.
YASKAWA TOEPYAIGA8002B GA800 Drive Programming
to select [Diagnostic Tools], then push
to select [Drive Information], then push
.
.
D - Drive Software Version
E - Serial Number
3.4 Keypad Operation
587
3