YASKAWA GA800 Programming Manual page 561

12.
Push or
• Push (Default) to set the parameters to the factory default.
• Push (Min/Max) to move between the minimum value and maximum value.
13.
Push to keep the changes.
14.
Push (Back).
If necessary, use the same procedure to set [Custom Monitor 2].
■
Set the Time Scale for the Trend Plot Monitor
The procedure in this section shows how to set the time scale for the trend plot monitor.
1.
Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push (Menu).
3.
Push or
4.
Push or
YASKAWA TOEPYAIGA8002B GA800 Drive Programming
to select the specified digit, then push
, push (Back) to show [Home] on
to select [Monitors], then push
to select [Trend Plot], then push
or to select the correct number.
.
.
(Setup).
3.4 Keypad Operation
561
3