YASKAWA GA800 Programming Manual page 580

3.4 Keypad Operation
4.
Push or
5.
Push or
Note:
This operation will initialize all parameters.
6.
Push or
7.
For the next steps, follow the instructions shown on the keypad until the "Parameter Change Confirmation
Screen" is shown.
8.
In the parameter change confirmation screen, push
select [Apply of each parameter] at the bottom of the screen and push
Note:
To change a parameter again, push
screen.
580
to select [Setup Wizard], then push
to select [Yes], then push
to select the item to set, then push
or to select the parameter to change, then push
.
.
.
or to examine the changed parameter, then
YASKAWA TOEPYAIGA8002B GA800 Drive Programming
.
to show the parameter setting