◆
Set Sinking Mode/Sourcing Mode
Close the circuit between terminals SC-SP and SC-SN to set the sinking mode/sourcing mode and the internal/
external power supply for the MFDI terminals. The default setting for the drive is internal power supply sinking
mode.
NOTICE: Do not close the circuit between terminals SP and SN. A closed circuit between these terminals will cause damage to the
drive.
Mode
Sinking Mode (NPN)
Sourcing Mode
(PNP)
◆
Set Input Signals for MFAI Terminals A1 to A3
Use terminals A1 to A3 to input a voltage or a current signal. Set the signal type as shown in
YASKAWA TOEPYAIGA8002B GA800 Drive Programming
Internal Power Supply (Terminal SN-SP)
Figure 4.30 Location of DIP Switch S1
4.6 Control I/O Connections
External 24 V power supply
Table
4.11.
4
633