YASKAWA GA800 Programming Manual page 521

■
o2-23: External 24V Powerloss Detection
No.
Name
(Hex.)
o2-23 External 24V Powerloss
Detection
(11F8)
RUN
Note:
The drive will not run when it is operating from one 24-V external power supply.
0 : Disabled
The drive does not detect the loss of the 24-V external power supply.
1 : Enabled
The keypad shows the L24v [Ext. 24-V Power Supply Lost] indicator when the drive detects the loss of the 24-V
external power supply.
Note:
The minor fault signal is not output from H2-xx = 10 [Multi-Function Digital Out = Minor Fault].
■
o2-24: LED Light Function Selection
No.
Name
(Hex.)
o2-24 LED Light Function
Selection
(11FE)
Note:
When you use A1-03 [Initialize Parameters] to initialize the drive, the drive will not reset this parameter.
0 : Enable Status Ring & Keypad LED
1 : LED Status Ring Disable
2 : Keypad LED Light Disable
■
o2-26: Alarm display at ext. 24V power
No.
Name
(Hex.)
o2-26 Alarm display at ext. 24V
power
(1563)
0 : Disabled
The drive will not detect EP24v [External Power 24V Supply] if the main circuit power supply voltage decreases. The
[Ready] light on the LED Status Ring flashes quickly to identify that drive operation is not possible.
1 : Enabled
The drive detects EP24v when the main circuit power supply voltage decreases.
Note:
The minor fault signal is not output from H2-xx = 10 [MFDO Function Selection = Alarm].
■
o2-27: bCE Detection Selection
No.
Name
(Hex.)
o2-27 bCE Detection Selection
(1565)
0 : Ramp to Stop
1 : Coast to Stop
2 : Fast Stop (Use C1-09)
YASKAWA TOEPYAIGA8002B GA800 Drive Programming
V/f CL-V/f OLV CLV AOLV
Sets the function to give a warning when the backup external 24 V power supply turns off when the
main circuit power supply is in operation.
V/f CL-V/f OLV CLV AOLV
Sets the function to show the LED status rings and keypad LED lamps.
V/f CL-V/f OLV CLV AOLV
When you connect a backup external 24 V power supply, this parameter sets the function to trigger
an alarm when the main circuit power supply voltage decreases.
V/f CL-V/f OLV CLV AOLV
Sets drive operation if the Bluetooth device is disconnected when you operate the drive in Bluetooth
Mode.
2.11 o: Keypad-Related Settings
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Default
(Range)
0
(0, 1)
Default
(Range)
2
(0 - 2)
Default
(Range)
1
(0, 1)
Default
(Range)
3
(0 - 4)
2
521