Keypad Operation; Home Screen Display Selection - YASKAWA GA800 Programming Manual

3.4

Keypad Operation

Note:
Make sure that you use a keypad with FLASH number 1004 or later. Keypads with FLASH numbers 1003 and earlier will not show
characters correctly.
◆

Home Screen Display Selection

This section gives information about the functions that you can control from the HOME screen and the content shown
on the HOME screen.
■
View Monitors Shown in Home Screen
This figure shows monitor data in the data display area of the HOME screen.
• To change what the screen shows, change the setting for o1-40 [Home display selection].
• When o1-40 [Home display selection] is set to "Custom Monitor", and there is more than one screen, use
to switch between screens.
■
JOG Operation
Push to illuminate
■
Change Motor between Forward/Reverse Run
You can change the direction of motor rotation when operating the drive from the keypad. Push
.
Push and hold (FWD/REV) to toggle the direction of motor rotation between forward and reverse.
■
Show the Standard Monitor
Push to show the standard monitor (Ux-xx). Push
Note:
When a fault, minor fault, or an error occurs, push
xx).
■
Change the Frequency Reference Value
1. Push to access the screen to change the frequency.
YASKAWA TOEPYAIGA8002B GA800 Drive Programming
. Push (JOG) to run the motor. Release
to show the content of the fault. Push
to stop the motor.
(HOME) to go back to the HOME screen.
again to show the standard monitor (Ux-

3.4 Keypad Operation

or
to illuminate
551
3