YASKAWA GA800 Programming Manual page 431

[Virtual Multi-Function
Note:
• Refer to H1-xx "MFDI Setting Values" for more information on the virtual digital input setting values.
• Refer to H2-xx "MFDO Setting Values" for more information on the virtual digital output setting values.
• Refer to H3-xx "MFAI Setting Values" for more information on the virtual analog input setting values.
• Refer to H4-xx "MFAO Setting Values" for more information on the virtual analog output setting values.
• You cannot select 0 [3-Wire Sequence] or 20 to 2F [External Fault] in H7-01 to H7-04 [Virtual Multi-Function Input 1 to 4].
• If the terminal is not used, set H7-01 to H7-04 = F. However, the through mode function is not supported.
• The virtual I/O function selection and the multi-function input for DI-A3 cannot be used simultaneously.
■
H7-00: Virtual MFIO selection
No.
Name
(Hex.)
H7-00 Virtual MFIO selection
(116F)
Expert
0 : Disabled
1 : Enabled
■
H7-01: Virtual Multi-Function Input 1
No.
Name
(Hex.)
H7-01 Virtual Multi-Function Input
1
(1185)
Expert
Note:
Settings 1B [Programming Lockout] and 11B [!Programming Lockout] are not available.
■
H7-02: Virtual Multi-Function Input 2
No.
Name
(Hex.)
H7-02 Virtual Multi-Function Input
2
(1186)
Expert
Note:
Settings 1B [Programming Lockout] and 11B [!Programming Lockout] are not available.
■
H7-03: Virtual Multi-Function Input 3
No.
Name
(Hex.)
H7-03 Virtual Multi-Function Input
3
(1187)
Expert
Note:
Settings 1B [Programming Lockout] and 11B [!Programming Lockout] are not available.
YASKAWA TOEPYAIGA8002B GA800 Drive Programming
H7-10
Output 1]
Figure 2.118 Virtual Digital I/O Functional Block Diagram
V/f CL-V/f OLV CLV
Sets the function to enable and disable the virtual I/O function. Set this parameter to 1 to operate the
virtual I/O function.
V/f CL-V/f OLV CLV
Sets the function that enters the virtual input set in H7-10 [Virtual Multi-Function Output 1].
V/f CL-V/f OLV CLV
Sets the function that enters the virtual input set in H7-12 [Virtual Multi-Function Output 2].
V/f CL-V/f OLV CLV
Sets the function that enters the virtual input set in H7-14 [Virtual Multi-Function Output 3].
H7-11
[Virtual Output [Virtual Multi-Function
1 Delay Time]
Description
AOLV OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
AOLV OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
AOLV OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
AOLV OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
2.8 H: Terminal Functions
H7-01
Input 1]
Default
(Range)
0
(0, 1)
Default
(Range)
F
(1 - 19F)
Default
(Range)
F
(1 - 19F)
Default
(Range)
F
(1 - 19F)
2
431