YASKAWA GA800 Programming Manual page 560

3.4 Keypad Operation
6.
Push .
7.
Push or
When the U parameters are on the display as "Ux-xx", the three digits in "x-xx" identify which monitor to
output. For example, to show monitor U1-01 [Frequency Reference], set it to "101" as shown in this figure.
8.
Push or
9.
Push or
• Push (Default) to set the parameters to the factory default.
• Push (Min/Max) to move between the minimum value and maximum value.
10.
Push to keep the changes.
11.
Push or
560
to select the monitor number to register, then push
to select [Trend Plot 1 Scale Minimum Value], then push
to select the specified digit, then push
to select [Trend Plot 1 Scale Maximum Value], then push
.
.
or to select the correct number.
.
YASKAWA TOEPYAIGA8002B GA800 Drive Programming