Show Monitors As Bar Graphs - YASKAWA GA800 Programming Manual

3.4 Keypad Operation
6.
Push .
7.
Push or
Enter the three digits in "x-xx" part of monitor Ux-xx to identify which monitor to output. For example, to show
monitor U1-01 [Frequency Reference], set it to "101" as shown in this figure.
The configuration procedure is complete.
◆

Show Monitors as Bar Graphs

The procedure in this section shows how to show a specific monitor as a bar graph. You can show a maximum of
three.
1.
Push (Home) to display the HOME screen.
Note:
• [Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [Home] is not shown on
2.
Push (Menu).
3.
Push or
4.
Push or
556
to select the monitor number to register, then push
, push (Back) to show [Home] on
to select [Display Monitor], then push
to select [Display Bar Graph], and push
.
.
.
.
YASKAWA TOEPYAIGA8002B GA800 Drive Programming