Displaying The Monitor - YASKAWA GA800 Programming Manual

3.4 Keypad Operation
2. Push or to select the digit, then push
3. Push to keep the changes.
Note:
The HOME screen must show U1-01 [Frequency Reference] or you must set the keypad as the Run command source (REMOTE) to use this
function.
■
Show the Main Menu
Push to show the main menu. Push
◆

Displaying the Monitor

This section shows how to show the standard monitor (Ux-xx).
1.
Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If the screen does not show [Home] for
2.
Push (Menu).
3.
Push or
4.
Push or
552
(HOME) to go back to the HOME screen.
, push
to select [Monitors], then push
to select [Standard Monitor], then push
or to change the value.
(Back), and then push
.
.
YASKAWA TOEPYAIGA8002B GA800 Drive Programming
to show [Home].