YASKAWA GA800 Programming Manual page 616

4.2 Removing/Reattaching Covers
2.
Pull the terminal cover away from the drive.
■
Reattach the Terminal Cover
Wire the drive and other peripheral devices then reattach the terminal cover.
Note:
• Wire the grounding terminals first, main circuit terminals next, and control circuit terminals last.
• Make sure that you do not pinch wires or signal lines between the wiring cover and the drive before you reattach the cover.
• Tighten the screws to a tightening torque of 0.98 N∙m to 1.33 N∙m (8.67 in∙lb to 11.77 in∙lb).
616
Figure 4.12 Remove the Terminal Cover
Figure 4.13 Reattach the Terminal Cover
YASKAWA TOEPYAIGA8002B GA800 Drive Programming