YASKAWA GA800 Programming Manual page 401

■
33: Zero Servo Complete
Setting Value Function
33 Zero Servo Complete
Note:
Refer to "b9: Zero Servo" for more information.
■
37: During Frequency Output
Setting Value Function
37 During Frequency Output
ON : The drive outputs frequency.
OFF : The drive does not output frequency.
Note:
The terminal deactivates in these conditions:
• During Stop
• During baseblock
• During DC Injection Braking (initial excitation)
• During Short Circuit Braking
■
38: Drive Enabled
Setting Value Function
38 Drive Enabled
■
39: Watt Hour Pulse Output
Setting Value Function
39 Watt Hour Pulse Output
Note:
Refer to "H2-06: Watt Hour Output Unit Selection" for more information.
■
3C: LOCAL Control Selected
Setting Value Function
3C LOCAL Control Selected
ON : LOCAL
The keypad is the Run command source or the frequency reference source.
OFF : REMOTE
YASKAWA TOEPYAIGA8002B GA800 Drive Programming
V/f CL-V/f OLV CLV AOLV
The terminal activates when positioning in the range set with b9-02 [Zero Servo Completion Window] completes after sending the
Zero-Servo command.
V/f CL-V/f OLV CLV AOLV
The terminal activates when the drive outputs frequency.
Figure 2.100 Active Frequency Output Time Chart
V/f CL-V/f OLV CLV AOLV
This terminal activates when the H1-xx = 6A [Drive Enable] terminal activates.
V/f CL-V/f OLV CLV AOLV
Outputs the pulse that shows the watt hours.
V/f CL-V/f OLV CLV AOLV
The terminal activates when the Run command source or frequency reference source is LOCAL.
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
2.8 H: Terminal Functions
401
2