Operational Flow - Toshiba e-STUDIO 5540C Service Manual

7.4 PM Support Mode
7.4.1 General Description
This equipment has a PM support mode which enables you to confirm the use status of each part (the
number of output pages or developed pages, and drive counts) requiring periodic replacement and also
the replacement record, as well as resetting counter values efficiently. This record can be printed out in
the list print mode.
7.4.2

Operational flow

PM support mode activated
[6]+[START]+[POWER]ON
Authentication screen
Main screen
Main unit list displayed
[CANCEL] pressed
Clear screen
Counter clear
confirmation displayed
Clear finished
Counter clear performed
* When the authentication screen appears, press [OK]. (Enter the password, if one has been set.)
* The screen goes back to the main screen when the counter clear is performed or the [CANCEL]
button is pressed after moving from the main screen, while it goes back to the sub screen after
moving from the sub screen.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
Main unit chosen
[SUB UNIT] pressed
[RETURN]
pressed
Main unit chosen
Sub screen
[RESET]
Sub unit list displayed
[CANCEL]
pressed
Sub unit chosen
[RESET] pressed
[INITIALIZE]
pressed
Clear finished
Fig. 7-2
7 - 5
Sub unit chosen
[DETAIL] pressed
[RETURN]
pressed
Sub unit detail screen
Sub unit detail displayed
(for developer unit)
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
PREVENTIVE MAINTENANCE (PM)
7