Backup Adi Key; Backup Encryption Key; Backup License - Toshiba e-STUDIO 5540C Service Manual

[G] Backup ADI key
Perform the following procedures if the ADI-HDD has been installed.
(1) Turn the power ON while pressing [3] and the [CLEAR] button simultaneously.
(2) Enter the password, and then press the [OK] button. (If the password is not set for Service, press
the [OK] button without entering anything.)
(3) Key in [5] to select "5. Key Backup Restore", and then press the [START] button.
(4) Key in [6] to select "6. ADIKey FROM to SRAM", and then press the [START] button.
(5) Wait until the backup of the ADI key is completed. "Operation Complete" is displayed.
(6) Restart the equipment after the backup is completed.
If you want to perform the backup of the license, do not restart the equipment but perform from
(4) in "[H] Backup encryption key".
[H] Backup encryption key
(1) Turn the power ON while pressing [3] and the [CLEAR] button simultaneously.
(2) Enter the password, and then press the [OK] button. (If the password is not set for Service, press
the [ENTER] button without entering anything.)
(3) Key in [5] to select "5. Key Backup Restore", and then press the [START] button.
(4) Key in [2] to select "2. Key FROM to SRAM", and then press the [START] button.
(5) Wait until the backup of the encryption key is completed. "Operation Complete" is displayed.
(6) Restart the equipment after the backup is completed. If you want to perform the backup of the
license, do not restart the equipment but perform from (4) in "[I] Backup license".
(7) Turn the power OFF.
[I]

Backup license

Notes:
If "3. License SRAM to FROM" is performed by mistake, carry out the following procedure.
 P. 9-48"[ 1 ] Re-registration when the board is replaced"
(1) Turn the power ON while pressing [3] and the [CLEAR] button simultaneously.
(2) Enter the password, and then press the [OK] button. (If the password is not set for Service, press
the [ENTER] button without entering anything.)
(3) Key in [5] to select "5. Key Backup Restore", and then press the [START] button.
(4) Key in [4] to select "4. License FROM to SRAM", and then press the [START] button.
(5) Wait until the backup of the license is completed. "Operation Complete" is displayed.
(6) Restart the equipment after the backup is completed.
(7) Turn the power OFF.
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
REPLACEMENT OF PC BOARDS/HDD
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
9 - 38