Maximum Toner Density Adjustment To Paper Type; Maximum Text Density Adjustment - Toshiba e-STUDIO 5540C Service Manual

6.2.12

Maximum toner density adjustment to paper type

The maximum toner amount adhering to the paper can be controlled.
It is used when offsetting occurs.
Code
7913-0
7913-1
7913-2
7913-3
7913-4
7913-5
7913-6
7913-7
7913-8
7913-9
Notes:
Even if a large value is set, the image does not drastically appear dark (the amount of toner
adhering is not increased).
<Procedure>
The procedure is the same as that of  P. 6-33"6.2.2 Density adjustment".
6.2.13

Maximum text density adjustment

The maximum text density in each color in the full color mode (Text/Photo, Text, Map mode) can be
adjusted.
Color Code
Yellow 7889
Magenta 7890
Cyan 7891
Black 7892
Make a test copy and compare the image obtained with the current settings; if necessary, make
adjustments according to the following procedure.
Notes:
Be sure that this adjustment is made after performing  P. 6-31"6.2.1 Automatic gamma
adjustment".
<Procedure>
The procedure is the same as that of  P. 6-33"6.2.2 Density adjustment".
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
SETTING ADJUSTMENT
Paper type
Plain paper 1
Plain paper 2
Recycled paper
Thick paper 1
Thick paper 2
Thick paper 3
Thick paper 4
Special paper 1
Special paper 2
OHP film
Item to be adjusted
Maximum text density
Remarks
The smaller the value is, the toner amount adhered
decreases of the high density area (ex. prevention of
fusing offsetting, etc.).
Acceptable values: 0 to 255
(Default: 128)
The larger the value is, the darker the maximum
text density of each color to be adjusted becomes.
Acceptable values: 0 to 10 (Default: 5)
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
6 - 42
<Adjustment Mode (05)>
<Adjustment Mode (05)>
Remarks