Adjustment Procedure Of The Bypass Feed Unit - Toshiba e-STUDIO 5540C Service Manual

(4) Tighten the screw that was temporarily
screwed.
Notes:
In this step check the film attached before
the separation roller because the roller life
may become shorter if this film is scraped
and worn.
Reference value of distance C (from the
edge of the plate to that of the film): 7.0±0.2
mm
* If the distance C is 6.5 mm or shorter, the
film must be replaced.

[ 2 ] Adjustment procedure of the bypass feed unit

(1) Take off the bypass feed tray.
 P. 4-45"4.5.1 Bypass feed tray"
(2) Remove 1 screw and take off the bracket [1].
(3) Remove 4 screws and take off the SFB lower
unit [1].
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
Fig.6-34
Fig.6-35
Fig.6-36
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
6 - 85
C
[1]
[1]
SETTING ADJUSTMENT
6