Toshiba e-STUDIO 5540C Service Manual page 836

Replace parts
Original exit sensor
RADF board
Roller
[E724] Stop jam at the original registration sensor
Classification
RADF jam
Check item
Registration roller
Original registration sensor
RADF board
Drive unit, Rollers
Replace parts
Original registration sensor
RADF board
Roller
[E726] Transport/exit signal reception jam during ADF standby status
Classification
RADF jam
Check item
RADF
Equipment
[E727] Jam not reaching the original reading end sensor
Classification
RADF jam
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
Perform the 05-3210
Read roller
The trailing edge of the original does not pass the original
registration sensor after its leading edge has reached this
sensor.
• Cleaning
• Sensor check
(Perform the input check: 03-[FAX]ON/[7]/[H])
• Connector check
• Harness check
• Connector check (CN74)
• Board check
• Gear check
• Roller check
Perform the 05-3210
Registration roller
• Check if there is any paper in the RADF. Remove it if there
is.
• Check if there is any paper in the equipment. Remove it if
there is.
• If a jam still occurs, turn the power OFF and then back ON
to check if the equipment operates normally.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
8 - 80
Remarks
Error item
Measures
Remarks
Error item
Measures
Error item