4.9.10
Fuser belt rotation detection sensor (S49)
(1)
Take off the pressure roller cover.
P. 4-173"4.9.2 Pressure roller cover"
(2)
Take off the transport guide-1.
P. 4-174"4.9.3 Transport guide-1"
(3)
Take off the transport guide-2.
P. 4-174"4.9.4 Transport guide-2"
(4)
Remove 1 screw and the bracket [1] of the
fuser belt edge thermistor.
(5)
Remove 3 screws and take off the front
upper frame [2].
(6)
Remove 1 screw and the bracket [3] of the
fuser belt rotation detection sensor.
(7)
Release a harness from 1 clamp [4] and then
disconnect a connector [5].
(8)
Remove the fuser belt rotation detection
sensor from the bracket.
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
[ 1 ]
[ 4 ]
Fuser belt rotation detection sensor
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
4 - 188
[ 3 ]
[ 5 ]
Fig. 4-545
Fig. 4-546
[ 2 ]