(12) Repeat step (6) to (11). If you can confirm that all gaps are the correct values, end the procedure.
Notes:
If the separation plate gap is not adjusted correctly, the problems below may occur.
•
If the gap is too large, paper jams may occur frequently when photo images are copied on thin
paper.
•
If the gap is too small, stains may appear on the copied image because the separation plate
may scratch the fuser belt.
1
[2]
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
2
3
[1]
Fig.6-83
6 - 111
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
SETTING ADJUSTMENT
6