Check item
Finisher controller board
Replace parts
Front cover switch (SW1)
Stationary tray opening/closing
switch (SW2)
Finisher controller board
[EA50] Stapling jam
Classification
Finisher jam
(Finisher section)
Check item
Finisher
Stapler interference sensor (S11)
Finisher controller board
Replace parts
Stapler interference sensor (S11)
Finisher controller board
[EA60] Early arrival jam
Classification
Finisher jam
(Finisher section)
Check item
Finisher
Entrance sensor (S1)
Finisher controller board
Replace parts
Entrance sensor (S1)
Finisher controller board
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
•
Connector check(CN16)
•
Board check
[MJ-1103/1104]
•
Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if there is.
•
Is the jam cleared by taking off the staple cartridge from
the finisher and removing the staple sheet slid from the
staple case?
•
Sensor check
•
Connector check
•
Harness check
•
Connector check(CN2)
•
Board check
The inlet sensor detects the paper earlier than a specified
timing. [MJ-1103/1104]
•
Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if there is.
•
Sensor check
•
Connector check
•
Harness check
•
Connector check(CN7)
•
Board check
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
8 - 94
Measures
Remarks
Error item
Measures
Remarks
Error item
Measures
Remarks