Paper Jam In Puncher Unit - Toshiba e-STUDIO 5540C Service Manual

Replace parts
Feeding sensor (S22)
Junction box paper detection sensor
(S26)
Transport path-2 (S27)
Transport path-3 (S28)
Ejecting roller (S29)
Interface PC board (I/F)
Saddle stitcher controller board
Finisher controller board
8.3.11

Paper jam in puncher unit

[E9F0] Punching jam
Classification
Finisher jam
(Punch unit)
Check item
Finisher, saddle stitcher
Punch HP sensor (S4)
Punch motor (M3)
Punch controller board
Replace parts
Punch HP sensor (S4)
Punch motor (M3)
Punch controller board
8.3.12 Other paper jam
[EAD0] Print end command time-out jam
Classification
Other paper jam
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
[MJ-6102]
• Check if there is any paper in the finisher, punch unit or
the on the transport path of the equipment. Remove it if
there is.
• Sensor check
• Connector check
• Harness check
• Motor check
• Connector check
• Harness check
• Connector check
• Board check
The printing has not finished normally because of an error
occurring on the interface between the SYS board and the
engine firmware at the end of printing.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
8 - 98
Remarks
Error item
Measures
Remarks
Error item