Check item
Setting
Replace parts
SYS board
[2B31] Status of specified Electronic Filing or folder is undefined or being created/deleted
Classification
Electronic Filing related error
Check item
Setting
Replace parts
[2B50] Image library error
[2B90] Insufficient memory capacity
Classification
Electronic Filing related error
Check item
Setting
Replace parts
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
•
Erase some data in the Electronic Filing or the shared
folder and perform the job in error again (in case of
[2B30]).
•
Turn the power OFF and then back ON. Perform the job in
error again.
•
Check that there is no other job in progress, and format
the HDD with [5] + [C] + [POWER].
•
If the recovery is still not completed, replace the SYS
board.
•
Check if the specified Electronic Filing or folder exists. (If
no, this error would not occur.)
•
Delete the specified Electronic Filing or folder.
•
Perform the job in error again.
•
If the specified box/folder cannot be deleted, initialize the
Electronic Filing with [5] + [C] + [POWER].
•
Turn the power OFF and then back ON. Perform the job in
error again.
•
If the error still occurs, replace the main memory.
•
Delete the job in progress or being set or in the HOLD/
PRIVATE/PROOF/INVALID, and retry the job in error.
•
Check that there is no other job in progress, and initialize
the Electronic Filing with [5] + [C] + [POWER].
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
8 - 220
Measures
Remarks
Error item
Measures
Remarks
Error item
Measures
Remarks