[D] Image position of secondary scanning direction (Laser writing start position)
Performing the code 05-4402 covers this adjustment for all paper sources.
The adjustment for each paper source is also available.
For all paper sources
Code
Paper size
4402
For each paper source
<4-drawer model>
Order for
Paper source
adjustment
1
1st drawer
2
2nd drawer
3
3rd drawer
4
4th drawer
5
Bypass feed
6
Duplex feeding
7
Option LCF
<Tandem LCF model>
Order for
Paper source
adjustment
1
1st drawer
2
2nd drawer
3
Tandem LCF
4
Bypass feed
5
Duplex feeding
6
Option LCF
1. While pressing [0] and [5] simultaneously, turn the power ON. (Adjustment Mode)
2. Press [98] ([3] for duplexing) [FAX]. (A grid pattern with 10 mm squares is printed out.)
3. Measure the distance D from the leading edge of the paper to the 6th line of the grid pattern.
* Normally, the 1st line of the grid pattern is not printed.
* At the duplexing, measure it on the top side of the grid pattern.
4. Check if the distance D is within 52±0.5 mm.
5. If not, use the following procedure to change values and measure the distance D again.
<Procedure>
(Adjustment Mode) (Key in the code shown above) [START]
(Key in an acceptable value shown above)
[OK] or [INTERRUPT] (Stored in memory)
"100% A" is displayed
Press [98] ([3] for duplexing)
[FAX] (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance D becomes
(approx. 0.10 mm/step).
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
SETTING ADJUSTMENT
Acceptable value
A3/LD
0 to 200
Code
Paper size
4058
4059
4060
4560
4061
4062
4063
Code
Paper size
4058
4059
4561
4061
4062
4063
Performs the adjustment for all paper sources.
Acceptable
value
A4/LT
0 to 100
A3/LD
0 to 100
A4/LT
0 to 100
A4/LT
0 to 100
A4/LT
0 to 100
A3/LD
0 to 100
A4/LT
0 to 100
Acceptable
value
A4/LT
0 to 100
A3/LD
0 to 100
A4/LT
0 to 100
A4/LT
0 to 100
A3/LD
0 to 100
A4/LT
0 to 100
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
6 - 20
Remarks
Remarks
Paper fed from the 2nd drawer
Only when the optional LCF is
installed
Remarks
Paper fed from the 2nd drawer
Only when the optional LCF is
installed