Toshiba e-STUDIO 5540C Service Manual page 841

[E870] RADF open jam
Classification
RADF jam
Check item
RADF
RADF opening/closing sensor
RADF board
Replace parts
RADF opening/closing sensor
RADF board
[E871] Cover open jam in the read ready status
Classification
RADF jam
Check item
RADF
Original jam access cover opening/
closing sensor
RADF board
Replace parts
Original jam access cover opening/
closing sensor
RADF board
[E890] ADF time out jam
Classification
RADF jam
Check item
RADF
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
RADF has opened during RADF operation.
• Close the RADF if it is opened.
• Remove if there is any original before closing it.
• Sensor check
(Perform the input check: 03: [FAX]/ON/[7]/[D])
• Connector check
• Harness check
• Connector check (CN74)
• Board check
Perform the 05-3210
Jam caused by opening of the Original jam access cover or
front cover while the RADF is waiting for the scanning start
signal from the equipment.
• Close the RADF if it is opened.
• Remove if there is any original before closing it.
• Sensor check
(Perform the input check: 03: [FAX]/ON/[7]/[C])
• Connector check
• Harness check
• Connector check (CN74)
• Board check
Perform the 05-3210
ADF time out jam
• Check if there is any paper in the RADF. Remove it if there
is.
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
8 - 85
Error item
Measures
Remarks
Error item
Measures
Remarks
Error item
Measures
ERROR CODE and TROUBLESHOOTING
8