Paper Dust Cleaning Brush (Registration Roller); Registration Guide - Toshiba e-STUDIO 5540C Service Manual

(4) Remove 2 holders, 2 bearings, 3 E-rings, 1
gear, 1 ground plate and 1 pin from the
registration roller.
Notes:
Make sure that the holders and the bearings
are installed in a correct position because
those for the front side differ from those for
the rear side.
4.5.26

Paper dust cleaning brush (registration roller)

(1) Take off the 2nd transfer unit.
 P. 4-154"4.7.14 2nd transfer unit (TRU)"
(2) Remove 2 screws and slide the bracket of
the brush toward you.
(3) Take off the paper dust cleaning brush
quietly not to hit the bracket to the
registration roller.
Notes:
Clean paper dust on the brush, if any.
4.5.27

Registration guide

(1) Open the duplexing unit.
(2) Remove 3 screws and slide the registration
guide slightly to the rear side to release the
front hook.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
Bearing
Fig. 4-181
Paper dust cleaning brush (registration roller)
Fig. 4-182
Fig. 4-183
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
4 - 63
Registration roller (rubber)
Bearing
Registration guide
Shoulder screw
DISASSEMBLY and REPLACEMENT
4