Check item
Power
SYS board
LGC board
Replace parts
SYS board
LGC board
[EAE0] Receiving time-out jam
Classification
Finisher jam
Check item
Finisher
Finisher controller board
Replace parts
Finisher controller board
[EB30] Ready time-out jam
Classification
Finisher jam
Check item
Finisher
Finisher controller board
LGC board
Replace parts
Finisher controller board
LGC board
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
•
Check if the error is cleared by turning the power OFF and
then back ON.
•
Connector check
•
Board check
•
Connector check
•
Board check
The printing has been interrupted because of the
communication error between the equipment and finisher
when the paper is transported from the equipment to the
finisher.
•
Is the finisher working?
•
Check if the voltage (24V) is being supplied to the finisher.
•
Connector check
•
Board check
The equipment judges that the paper transport to the finisher
is disabled because of the communication error between the
equipment and finisher at the start of printing.
•
Check if there is any paper in the equipment. Remove it if
there is.
•
Connector check
•
Board check
•
Connector check
•
Board check
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
8 - 99
Measures
Remarks
Error item
Measures
Remarks
Error item
Measures
Remarks
ERROR CODE and TROUBLESHOOTING
8