[F106_5] ADI-HDD error: Authentication data transmission error
Classification
Other service call
Check Item
Setting
HDD
[F106_6]/[F106_7]/[F106_8]/[F106_10] /[F106_UNDEF] ADI-HDD error: Error caused by reason
other than F106_0 to 5 errors
Classification
Other service call
Check Item
Setting
HDD
[F109_0] Key consistency error (Consistency check operation error)
Classification
Other service call
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ADI-HDD error: The transmission of authentication data fails.
Reinstall the system ROM data (OS Data).
Reinstall the master data (HD Data).
•
In case this error occurred after returning SRAM data for
SRAM cloning:
Copy the ADI-HDD encryption key from FROM to SRAM.
(1)
Start the equipment in the 3C mode: [3] + [C] + [POWER]
(2)
The authentication menu is displayed. Press [OK]. (Not
required in the default setting)
(3)
Select "5. Key Backup Restore" and then press the
[START] button.
(4)
Select "6. ADIKey FROM to SRAM" and then press the
[START] button.
(5)
After the restoring of the encryption key has completed,
"Operation Complete" is displayed.
(6)
After the operation has completed, shut down the
equipment by pressing the [POWER] button.
If the error persists even after above step, replace the HDD. If
the equipment operation disabled after above step, replace the
HDD.
ADI-HDD error: Error caused by reason other than F106_0 to 5
errors
Perform [3]+[C]+[POWER]-> [3.Format HDD], and then install
the system software by performing [4]+[9]+[POWER]->
[4.System Software(HD data)].
Notes:
The following items will be deleted by performing
[3]+[C]+[POWER]-> [3.Format HDD].
•
Message Log
•
Job Log
•
Spool Data (Print, Email reception)
•
Template
If the error persists even after above step, replace the HDD. If
the equipment operation disabled after above step, replace the
HDD.
Key consistency error - Key consistency check on each key
data fails.
8 - 197
Error item
Measure
Error item
Measure
Contents
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8