9.2.3
Precautions and procedures when replacing the HDD
Notes:
•
Replacing ADI-HDD with SATA-HDD is not possible. When replacing ADI-HDD, replace it with
another ADI-HDD.
•
When the HDD is replaced, it is necessary to back up the data in the HDD before replacing
and to recover them after replacing.
•
To maintain the security, ask users to perform the backup/restore for users' data/information
in the HDD. The service technician can perform them only when users permit it.
•
Some data in the HDD cannot be backed up and can be kept only on the paper.
•
Do not replace the HDD and the SRAM board (for the SYS board) together.
•
When the HDD is replaced, do not perform SRAM data formatting (Clear SRAM) before the
normal start-up.
•
When the HDD is replaced, do not restore the back-up file before the normal start-up.
A procedure for replacing the HDD is shown below.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
Start
[A] Back up data in HDD
[B] Print out "FUNCTION LIST FOR MAINTENANCE"
[C] Print out "FUNCTION" list
[D] Erase HDD
[E] Replace/Format HDD
[F] Reset user's setting item and restore data/information
[G] Reset "FUNCTION LIST FOR MAINTENANCE"
[H] Reset "FUNCTION" list
[I] Adjust image quality
Setting completed
Fig. 9-65
9 - 25
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
REPLACEMENT OF PC BOARDS/HDD
9