2Nd Transfer Roller Contact/Release Detection Sensor - Toshiba e-STUDIO 5540C Service Manual

(3) Remove 1 connector [1] and 3 screws, and
take off the transfer belt motor (M13) [2].
4.7.25 2nd transfer roller contact/release detection sensor (S50)
(1) Take off the middle guide.
 P. 4-78"4.5.48 Transfer belt paper
clinging detection sensor (S47)"
(2) Remove 2 screws, and once the cam shaft is
moved toward the front, lift up a little and
take it off.
(3) Disconnect 1 connector [1] and release 3
harness clamps [2]. Then take off the cam
unit.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
[ 2 ]
Fig. 4-477
[ 1 ]
Fig. 4-478
Fig. 4-479
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
4 - 163
[ 1 ]
[ 1 ]
[ 2 ]
DISASSEMBLY and REPLACEMENT
4