Initialize Sram System Storage Area; Restore Sram; Clear Sram Update Error Flags - Toshiba e-STUDIO 5540C Service Manual

[D] Initialize SRAM system storage area
(1) Turn the power ON while pressing [6] and [CLEAR] simultaneously.
(2) When "SRAM Clear Mode" appears on the LCD, key in [1] to select "1. Clear SRAM" and then
press the [START] button.
(3) When "SRAM Format Completed" is displayed on the LCD, initializing is completed.
(4) Turn the power OFF.
[E] Restore SRAM
If there is SRAM backup data, perform the following steps.
(1) Turn the power ON while pressing [6] and the [CLEAR] button simultaneously.
(2) When "SRAM Clear Mode" appears on the LCD, key in [0] to select "0. Set Serial Number" and
then press the [START] button.
(3) Key in the serial number on the label attached to the rear cover of the equipment, and then press
the [OK] button.
(4) "Serial Number Setting completed" is displayed.
(5) Turn the power OFF.
(6) Install the USB media in the equipment, and then turn the power ON while pressing [5] and [9]
simultaneously.
(7) Key in [2] to select "2. Restore SRAM Data from USB" and then press the [START] button.
(8) Enter the password set for the backup data.
(9) Enter the serial number of the backup file.
(10) Turn the power OFF after the restoring of SRAM is completed.
Remarks:
When the restoration is completed successfully, do not perform "[F] Clear SRAM update error
flags" or later procedures.
End this procedure here and finish replacing the SRAM board (for SYS board).
(11) Reinstall the GD-1270 Fax Unit if used.
[F] Clear SRAM update Error flags
(1) Turn the power ON while pressing [3] and the [CLEAR] button simultaneously.
(2) Enter the password, and then press the [OK] button. (If the password is not set for Service, press
the [ENTER] button without entering anything.)
(3) After "Firmware Assist Mode" is displayed on the LCD, check that "1:
Software Installation
If not, key in [1] and then press the [START] button.
(4) When "Operation Complete" is displayed on the LCD, clearing the flag is completed.
(5) Turn the power OFF.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
." is marked and press the [START] button.
9 - 37
Clear Error Flag in
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
REPLACEMENT OF PC BOARDS/HDD
9