Toshiba e-STUDIO 5540C Service Manual page 827

Replace parts
LGC board
HDD
[E0A0] Image transport ready time-out jam
Classification
Other paper jam
Check item
Other
Power
SYS board
IMG board
LGC board
HDD
Replace parts
SYS board
IMG board
LGC board
HDD
[E550] Paper remaining on the transport path
Classification
Other paper jam
Step Check Item
Jamming transport path
1
Feed or transport roller possibly
2
causing multiple feeding
Sensor in the jamming area
3
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
Image data to be printed cannot be sent.
• Remove the paper remained in front of the registration
sensor.
• If the error still occurs, check the following.
Check if the error is cleared by turning the power OFF and
then back ON.
• Connector check (SYS board -IMG board) (CN135)
• Board check
• Connector check (IMG board -SLG board) (IMG board -
LGC board) (CN422, CN423, CN424)
• Harness check
• Board check
• Connector check (CN319, CN320)
• Harness check
• Board check
• Connector check
• HDD check
The paper is remaining on the transport path when printing is
finished (caused by a multiple paper feeding).
Result
Open the cover of the unit/area whose
picture is flashing on the control panel
and remove any paper on the transport
path.
Check the feed roller.
• Sensor check (Refer to the table
below)
• Harness check
• Connector check
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
8 - 71
Remarks
Error item
Measures
Remarks
Error item
Measure
ERROR CODE and TROUBLESHOOTING
8
Next
Step