License Re-Registration Using The One-Time Dongle; Re-Registration When The Board Is Replaced; Re-Registration When The Equipment Is Replaced Due To Malfunction - Toshiba e-STUDIO 5540C Service Manual

9.2.9

License re-registration using the one-time dongle

[ 1 ] Re-registration when the board is replaced

The license registered using the one-time dongle can be re-registered only in the same equipment.
When the SYS board or SRAM board (for SYS board) is replaced, follow the procedures for re-
registration given below.
(1) Start up with the Setting Mode (08).
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(3) Key in [3840], and then press the [START] button.
(4) Press the [INSTALL] button.
(5) Install the one-time dongle in the equipment (the one which you used for registering the selected
license), and then press the [OK] button.
(6) Select the license to be installed, and then press the [INSTALL] button.
(7) The screen for notifying that the installation will be started is displayed. Then press the [YES]
button.
(8) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [CLOSE] button. Then check that the one-time
dongle, which you used for uploading the selected license, is installed in the equipment.
(9) Check that the installed license is displayed on the license list.
Remarks:
If there are any other licenses to be returned, repeat from step (4). If there are no other licenses
to be returned, press the [CLOSE] button, and then turn the power OFF.
Notes:
This procedure is available only with the one-time dongle used for the previous registration, since
the model information registered in it is utilized. Use the same one-time dongle and the
equipment when registering the license.

[ 2 ] Re-registration when the equipment is replaced due to malfunction

When the equipment has to be replaced due to a malfunction, return the license registered in the
equipment to the one-time dongle and register it to the new equipment following the procedure below.
Notes:
The license of the IPSec Enabler (GP-1080) cannot be reinstalled. The one-time dongle to be
used is the one for the previous registration of the license. The license is deleted from the
equipment and is stored in the one-time dongle.
Do not perform the deletion of PDFA Converter since it is deleted without any return to the one-
time dongle.
(1) Start up with the Setting Mode (08).
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(3) Key in [3840], and then press the [START] button.
(4) Select the license to be returned, and then press the [REMOVE] button.
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
REPLACEMENT OF PC BOARDS/HDD
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
9 - 48