Bridge Unit Path Exit Sensor - Toshiba e-STUDIO 5540C Service Manual

(5) Take off the bridge unit path entrance sensor
from the sensor bracket.
4.10.26 Bridge unit path exit sensor (S56)
(1) Open the front cover and then pull out the
bridge unit.
(2) Remove 1 screw and then take off transport
guide-4 by sliding it.
(3) Release the harness from 2 clamps and then
disconnect the connector.
(4) Take off the sensor bracket by removing 1
screw.
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
Bridge unit path entrance sensor
Transport guide-4
Sensor bracket
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
4 - 230
Fig. 4-667
Fig. 4-668
Fig. 4-669