Paper Jam In Finisher Section - Toshiba e-STUDIO 5540C Service Manual

8.3.9

Paper jam in finisher section

[EA10] Transport delay jam (paper not inserted)
Classification
Finisher jam
(Finisher section)
Check item
Finisher
Feeding sensor (S22)
Transport path switching solenoid
(SOL5)
Entrance motor (M1)
Interface PC board (I/F)
Finisher control PC board (FIN)
Replace parts
Feeding sensor (S22)
Transport path switching solenoid
(SOL5)
Entrance motor (M1)
Interface PC board (I/F)
Finisher control PC board (FIN)
[EA20] Paper transport jam in Finisher (entrance sensor)
Classification
Finisher jam
(Finisher section)
Check item
Finisher
Entrance sensor (S1)
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
Check if there is any paper in the finisher or on the transport
path of the equipment and remove it if there is.
Check if there is a disconnection of the connector, incorrect
installation or breakage of the feeding sensor (S22). If there
is, reinstall the sensor correctly or replace it.
Check that the gap between the transfer guide surface and
the upper surface of the flapper tip is in the acceptable range
according to the status of the transport path switching
solenoid (SOL5) (solenoid OFF: 1.5 to 2.1 mm, solenoid ON:
2.3 to 2.9 mm). If it is not, adjust it.
Check the harness between the entrance motor (M1) and the
finisher controller board (CN26). If there is any abnormality,
correct it.
Check the harness between the transport path switching
solenoid (SOL5) and the interface PC board (CN6), If there is
any abnormality, correct it.
• Board check
• Connector check (CN5, CN6, CN7)
• Harness check
• Board check
• Connector check (CN25, CN27)
• Board check
Check if there is any paper in the finisher or on the transport
path of the equipment and remove it if there is.
• Sensor check
• Connector check
• Harness check
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
8 - 88
Error item
Measures
Remarks
Error item
Measures