Operational Screen - Toshiba e-STUDIO6520C Service Handbook

5.4.3

Operational screen

The description of the display (including the function of each button) on the LCD screen is shown
below.
1. Main screen
1
2
Displaying of the main unit name
1
Back to the PM support mode activation screen
2
Moving to the clear screen to clear the selected unit counters
3
(parts) counters belonging to that unit When the unit is not selected, all counters are cleared.
Moving to the sub screen of the selected unit
4
Moving to the next/previous page
5
Displaying of the present number of printed / developed pages
6
When there are differences among the sub units (parts), "-" is displayed and "CHECK
SUBUNIT" is displayed at the top
"*" is displayed next to the present number when the number of printed / developed pages has
exceeded its PM standard number.
Displaying of the standard number of printed / developed pages to replace the unit parts
7
Displaying of the present drive counts
8
"*" is displayed next to the present number when the number of drive counts has exceeded its
PM standard number.
Displaying of the standard number of drive counts to replace the unit parts
9
Displaying of the number of printed / developed pages (Page/D. cnt), drive counts (Cnt.) and
10
previous replacement date (Chg.) for a chosen unit
When the replacement date for the sub unit is different, press the [SUB UNIT] button to move
to the sub screen and see each information, otherwise information is not displayed
Notes:
1. "—" is always displayed at the drive counts section for the reversing automatic document
feeder (RADF) and feed unit.
2. "—" is displayed at the numeric section for the paper source which is not installed since the
paper source is different depending on the structure of options.
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
6
3 4 5
Fig. 5-3
5 - 7
10
7 8 9
and , including all sub unit
6 8
e-STUDIO5520C/6520C/6530C
PREVENTIVE MAINTENANCE (PM)
5