L10: Transfer Belt Cleaner Side Seal - Toshiba e-STUDIO 5540C Service Manual

* l10: Transfer belt cleaner side seal

Be sure to attach the transfer belt cleaner side seals according to the criteria in the figure below.
Part A: Pay attention to the following. If the blade is caught by the side seal or comes up on to it,
the blade may turn up. If the gap between the blade and the side seal is too wide, this will cause
toner scattering.
0~0.5 mm
A
After the side seals are attached, move the bracket retaining the blade and check that it is neither
caught nor comes up on to the side seal.
When replacing the transfer belt cleaner side seal, check if the molded part on the back side of
the removed recovery blade is dirty. Clean it if required.
Notes:
• Do not use alcohol because urethane foam will be removed.
• Cleaning on the back side of the Mylar is not necessary even if it is dirty.
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
PREVENTIVE MAINTENANCE (PM)
Fig. 7-31
Side seal
Blade
Fig. 7-32
Urethane foam
Cleaning
Mylar
Fig. 7-33
7 - 32
Normal Being caught
Side seal
Blade
Recovery blade
Urethane foam
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
0~0.5 mm
A
Coming up on
Side seal
Blade