Radf Opening/Closing Switch Adjustment - Toshiba e-STUDIO 5540C Service Manual

6.12.7

RADF opening/closing switch adjustment

Adjust the bracket position so that the sensor is turned ON when the height "J" becomes 145 mm or
less (within the empty weight falling limit).
(1) Take off the RADF rear cover.
 P. 4-258"4.11.3 RADF rear cover"
(2) Loosen the fixing screw of the bracket. Slide
the bracket vertically using the scale as a
guide to adjust the position where the switch
is turned ON.
(3) Tighten the fixing screw of the bracket. Install
the RADF rear cover.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
Fig.6-117
Scale
Screw
Bracket
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
6 - 125
Fig.6-118
SETTING ADJUSTMENT
6