Toshiba e-STUDIO 5540C Service Manual page 268

Notes:
Do not install the process unit with too much
force. Follow the procedure below when
installing the process unit.
1. Hold the levers on both sides and insert
the EPU tray slowly until it seems to
stop.(The stud should be inserted into the
hole of the frame.)In this case, the levers
face the inside.
2. Place your hands in the position indicated
by the arrows below, and push it well.
3. Turn both levers outside by 90 degrees
and push them down.
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
4 - 94
Stud Hole
Fig. 4-273
Fig. 4-274
2
2
Fig. 4-275
1
1